|
Hardware Installation The MX212 is very
simple to install and get up and running quickly.
**click to enlarge**
The display is easily mounted on a free 5.25"
bay with the included screws. The USB cable is already attached so just
feed it through an opening on the rear of your case (PCI Slot opening will do)
and connect the cable to an available USB port.
**click to enlarge**
|
**click to enlarge** |
**click to enlarge** |
Software Installation
Drivers for the display are included in the
ECD but can also be downloaded from the
Matrix Orbital
website. I did have trouble installing the drivers on on the CD but the
drivers on the website worked just fine.
Once you plug the device in, the new hardware
wizard should appear. Simple select advanced and browse out to the
directory where you have downloaded and extracted the driver files.
If installing on a Windows XP
machine, you will get the driver warning. Just click on Continue Anyway
and it will begin installing the proper files. That's it!
You should see the display under
your USB Controllers and a COM port assigned to it under Ports.
Finally, a shot of the display
properly installed:
**click to enlarge**
Looks great doesn't it?
The MX2 USB display is available in a variety of colors to go along nicely
with any setup.
|
